I'm selling a vance jpl4200 2" set back manual jack plate specifically built for jet boat applications.

https://www.vancemfg.com/2-inch-setback-p/jpl4200.htm

If offers 3.5" of adjustment, ideal for fine tuning your jet boat height.

115 max hp

The engine side holes of the jack plate are drilled 2.25 inches higher than the transom side, which, when combined with the 3.50 inches of adjustable vertical lift, means you can obtain 5.75 inches of maximum height to raise your long-shaft engine and make it workable on a short-shaft transom boat if needed!

Pre-drilled holes for 1/2'' stainless hardware
12 7/8'' across the top two holes from center to center
9 7/8'' across the bottom two holes from center to center
8'' of vertical distance between the top holes and bottom mounting holes

Buyer pays for shipping
$400 obo
Thanks