Motor Mount for Scadden Pontoons

[JAWallace]

SOLDHeavy duty motor mount for most any electric trolling motor, could probably support a small 1-2 hp gas motor as well.

I purchased this new from Dave Scadden's North Fork Outdoors, however only used my electric motor twice. This mount will fit his frameless Outlaw series (Predator, Escape, Renegade, Rampage, etc.), the Assault, and several other frameless boats from Scadden. It should fit some other frameless boats as well (see below).

Dimensions: The high point from the bottom of the legs to the top arch is 9". The distance between the two sets of legs (inside dimension) is 16". Weight is 7.25 lbs.

As can be seen, this mount is very flexible in size, and fastens to the craft with three heavy duty straps with cam cleats, intended to be cinched using D-rings on the craft. I had a 55 lb. Minn Kota on my Renegade, and it was as steady as a built in, and came off and attached in seconds.

To my knowledge these are no longer being manufactured, as most Scadden boats today have built in mounts, but they are rubber and not nearly as strong as this. Too bad, because they were absolute top quality, welded with bracing, seemingly indestructible. The price is a fraction of his retail price at the time which reflected the quality of the unit.

SOLD