Ryan
06-28-2022, 12:27 PM
Call Ryan at 707-365-9891. Gonna start asking at $19k for fly fisherman here. Will put to craigslist for 20k. I live right next to Lake Oroville. Test rides available for serious inquires.
Boat was completely restored in 2019-2020 w/ brand new motor. Currently has 132 hours on it. Still under warranty until Sept 2024. Also got new fuel line, wire harness, throttle cable, steering cable, anything coming from the motor into the boat is new. Rest of upgrades below… It is set up for fly fishing specifically the boat can fit a dozen fly rods (9-10’) (not including locker storage for shorter conventional rods)
Boat Hull is 100% composite fiberglass. Zero wood in boat. Extremely solid build. Made to last.
80lb minnkota terova with I-Pilot (Foot & hand control, spot lock, auto pilot, etc.) All new wiring
Minnkota on board 3 bank battery charger (one plug to charge all 3 batteries w/ auto shut off)
Lowrance Elite TI-5 w/navionics chip (in console: includes sidescan, gps, sonar, tides, etc.)
Ram mount on Lowrance
Humminbird Helix 5 in bow
Two 12v batteries for trolling motor & one 12v for engine & components
Rod locker can fit a ton of rods, lights, two livewells, ice chest, & bilge pump
Stainless Steel Prop
New flooring (SeaDek)
New seats & Fishing seats/pedestals included
Boat buckles bolted on trailer (ratchet straps for transom)
2.5 gallons of extra Evinrude high quality oil ($125 worth, will last 1-2 years for most people)
Boat cover & engine cover (Boat cover has a hole at trolling motor and needs to be patched)
Includes everything you need to get on water…
Ropes, dock fenders, fire extinguisher, throw pad, emergency paddle. Spare trolling motor prop w/bolts & cotter pins.
Smaller features include…
USB charger w/voltage meter
Upgraded bow w/ flush mount sonar, new modern switches.
New Fuse Box for all electronics & new wiring (Properly labeled fuses)
5 cup holders
Anchor line mount in bow
Extra rope cleat near steering wheel to dock & hook up without getting out of seat.
Brand new in box white marine speakers (not installed yet)
Trailer has been welded all over at one point to keep her running solid. In 2019 I installed new leaf springs, running boards, all new hardware, rims including spare, winch, fender grip tape, & LED lights.
Major work that has been done… In 2020, when I pulled the original carpet and installed the new seadek, I touched up the fiberglass work on the bare floor. Then repainted the entire front deck with gel coat, lastly installed the seadek. 95% of the holes that had been drilled all over the boat over the years have been fiberglassed and painted over. ZERO excess holes from multiple trolling motors over the years, old transducer holes, etc.
Boat & trailer has never been in salt or brackish water. Over the years the boat has been stored in a garage then for last 6 years it has been under a canopy w/ a cover.
Boat was completely restored in 2019-2020 w/ brand new motor. Currently has 132 hours on it. Still under warranty until Sept 2024. Also got new fuel line, wire harness, throttle cable, steering cable, anything coming from the motor into the boat is new. Rest of upgrades below… It is set up for fly fishing specifically the boat can fit a dozen fly rods (9-10’) (not including locker storage for shorter conventional rods)
Boat Hull is 100% composite fiberglass. Zero wood in boat. Extremely solid build. Made to last.
80lb minnkota terova with I-Pilot (Foot & hand control, spot lock, auto pilot, etc.) All new wiring
Minnkota on board 3 bank battery charger (one plug to charge all 3 batteries w/ auto shut off)
Lowrance Elite TI-5 w/navionics chip (in console: includes sidescan, gps, sonar, tides, etc.)
Ram mount on Lowrance
Humminbird Helix 5 in bow
Two 12v batteries for trolling motor & one 12v for engine & components
Rod locker can fit a ton of rods, lights, two livewells, ice chest, & bilge pump
Stainless Steel Prop
New flooring (SeaDek)
New seats & Fishing seats/pedestals included
Boat buckles bolted on trailer (ratchet straps for transom)
2.5 gallons of extra Evinrude high quality oil ($125 worth, will last 1-2 years for most people)
Boat cover & engine cover (Boat cover has a hole at trolling motor and needs to be patched)
Includes everything you need to get on water…
Ropes, dock fenders, fire extinguisher, throw pad, emergency paddle. Spare trolling motor prop w/bolts & cotter pins.
Smaller features include…
USB charger w/voltage meter
Upgraded bow w/ flush mount sonar, new modern switches.
New Fuse Box for all electronics & new wiring (Properly labeled fuses)
5 cup holders
Anchor line mount in bow
Extra rope cleat near steering wheel to dock & hook up without getting out of seat.
Brand new in box white marine speakers (not installed yet)
Trailer has been welded all over at one point to keep her running solid. In 2019 I installed new leaf springs, running boards, all new hardware, rims including spare, winch, fender grip tape, & LED lights.
Major work that has been done… In 2020, when I pulled the original carpet and installed the new seadek, I touched up the fiberglass work on the bare floor. Then repainted the entire front deck with gel coat, lastly installed the seadek. 95% of the holes that had been drilled all over the boat over the years have been fiberglassed and painted over. ZERO excess holes from multiple trolling motors over the years, old transducer holes, etc.
Boat & trailer has never been in salt or brackish water. Over the years the boat has been stored in a garage then for last 6 years it has been under a canopy w/ a cover.