lc-13 t14 question

[Mr T]

Is there a chart for determination of head legnth for rods using these lines?

I am awaiting two rods, a Dan Craft Signature V 9 and 10 weight.

I'd like to set up lines while waiting, but cannot find a guide for doing this.

Going to use the rods in the delta for stripers.

thanks

[Darian]

A rudimentary line chart comes packaged in each packet of Rio, T lines. Since each line sinks at the rate corresponding to the weight shown on the label (T-14 weighs 14 grains per foot), you can calculate the correct weight for your rod from those charts.... Of course, LC 13 weighs 13 grains per foot.... :cool:

[Bill Kiene semi-retired]

Most of the time 30 feet is good.

Shorter than 25 is not good and much over 30 is not good for the average caster either.